Filter
Top Products
Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.5 Configuring ASMi-52 System Parameters 4-15
ASMi-52
Local/Remote Card Mode
1. E1
2. DTE
3. E1 + LAN
4. E1 + V35
5. V35 + LAN
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-19. Local/Remote Card Mode Menu
Configuring Remote Card Mode
The remote card mode configuration option is only available when ASMi-52 is
connected to a remote unit. When connected to a remote unit, each multiplexer
unit can be configured to work as a single unit. For example, E1+Serial DTE, E1
single, or Serial DTE single may be configured as an E1or IR (Serial DTE) unit. A
multiplexer unit configured as a single unit does not behave as a multiplexer unit.
The following applies in remote card mode configuration.
• IR (DTE Serial Interface) as a single unit
• E1 as a single unit
• E1 + IR as a multiplexer unit.
To configure remote card mode:
1. From the Remote menu (Main menu > Configuration > System Configuration
> Remote Card Mode), select the appropriate configuration by choosing E1,
DTE, LAN, E1 + LAN, E1 + V35, or V35 + LAN (see Figure 4-19).
The System Configuration menu returns.
2. From the System Configuration menu, select Save to save the changes
Configuring Low Speed Operation
ASMi-52 can be configured to work at a speed of 64/128 kbps (2-wire) and
64/128/192/256 kbps (4-wire) when operating opposite devices with E1 DTE
interface. The maximum data rate of ASMi-52 working in low speed mode is
2048 kbps.
To enable the low speed operation:
1. From the System Configuration, select Low Speed Operation (Main menu >
Configuration > System Configuration > Low Speed Operation).
The option value changes to Enable or Disable.
2. From the System Configuration, select Save to save the change.
3. Reset the ASMi-52.
On start up the unit will operate in low speed mode.
Low speed operation is not available in multiplexed operations.
Note