Filter
Top Products
Chapter 9 Managing the SAN 119
Managing Switch Zones
For the following topics, see the SANBox-8/16 Switch Management User’s Manual: Sun
StorEdge Network FC Switch 3.0:
■ Adding a zone
■ Removing a zone
■ Removing a port from a zone
■ Adding an additional inter-switch link
■ Adding a host to an existing zone or switch
■ Verifying the results
■ Verifying the software patch revision
■ Verifying the software package revision
■ Verifying the firmware revision
Rezoning Hosts and Arrays
This section contains the following topics:
■ “Rezoning and Reassigning a Sun StorEdge A5200 Arrays from Host A to Host B”
on page 119
■ “Rezoning and Reassigning Sun StorEdge A3500FC LUNs from Host A to Host B”
on page 121
■ “Rezoning and Reassigning Sun StorEdge T3 Arrays from Host A to Host B” on
page 122
Rezoning and Reassigning a Sun StorEdge A5200
Arrays from Host A to Host B
Rezoning to reassign a storage device from host A and to host B causes host A to
loose all access to the storage device. To rezone a Sun StorEdge A5200 array from
one host to another host, perform the following two procedures:
■ “To Rezone a Sun StorEdge A5200 Array from Host A” on page 120
■ “To Rezone a Sun StorEdge A5200 Array to Host B” on page 120