Filter
Top Products
Chapter 4 Replacing Cold-Swappable Components 4-19
FIGURE 4-11 Removing the Battery From the Service Processor
4.5.1 Replacing the Battery on the Service Processor
1. Remove the replacement battery from the package.
2. Press the new battery into the service processor (
FIGURE 4-11) with the positive
side (+) facing upward (away from the card).
3. Place the edge of the service processor in between the tabs on the plastic
bracket and carefully align the connectors.
4. Press between the handle edges until the service processor is seated in the
connector.
5. Perform the procedures described in Section 4.8, “Finishing Component
Replacement” on page 4-28.