Chapter 4 Replacing Cold-Swappable Components 4-25
4.6.3 Creating a Bootable Array With the RAID 5
Expansion Module
If you are installing an operating system onto a bootable array, see Appendix B.
4.6.4 Additional Information
For more information, refer to the following documents at:
http://docs.sun.com/app/docs/coll/dsk-cntrl
■ Uniform Command-Line Interface User’s Guide, 820-2145
■ Sun StorageTek RAID Manager Software User’s Guide, 820-1177
■ Sun StorageTek RAID Manager Software Release Notes, 820-2755
For Sun RAID controller drivers, firmware, and utilities including Sun StorageTek
RAID Manager for SPARC (8/4/2008) Version 5.50, go to:
http://support.intel.com/support/motherboards/server/sunraid/
4.7 Removing and Replacing the Sun Blade
G2 RAID 0/1 Expansion Module
Caution – Avoid excess strain on the REM edges. Lift as close to the connector as
possible.
Removing the RAID 0/1 Expansion Module
1. Place your fingers under the RAID expansion module (REM), with each finger
close top the connector (
FIGURE 4-14).
2. Lift the card free from the connector.
3. Lift the REM free from the gray plastic standoff.