Filter
Top Products
Chapter 2 Sun Blade T6320 Server Module Diagnostics 2-39
2.6.4.1 Clearing Faults With the Web Interface
This procedure describes how to enable components after a POST fault has been
generated. The POST fault log is not actually cleared.
1. Select the tabs: System Information and Components tabs (
FIGURE 2-19).
2. Select the radio button for the component that you must clear.
3. In the Actions menu, select: Enable Component.
FIGURE 2-19 Enabling Components With the ILOM Web Interface
Note – The Clear Faults command in the Action menu will only clear the PSH-
generated faults, and will not enable a component.