C-2 Sun Blade T6320 Server Module Service Manual • June 2009
Note – For up-to-date Sun StorageTek SAS RAID HBA support, go to
http://support.intel.com/support/go/sunraid.htm
.
C.2 Installing the RAID 5 Expansion Module
Driver With the Solaris OS
This section contains the following subsection:
■ “To Install the RAID 5 Expansion Module Driver With the Solaris OS” on page 2
▼ To Install the RAID 5 Expansion Module Driver
With the Solaris OS
1. Obtain the Solaris 10 5/08 OS and perform a normal network installation, as
described in the Solaris 10 Installation Guide: Network-Based Installations, until you
encounter the prompt, Reboot After Installation?.
Note – Do NOT select Auto Reboot at this point in the network installation
process.
2. Specify that you want to perform a Manual Reboot.
Specifying a manual reboot provides you with the opportunity to install the HBA
driver after all other Solaris software is in place. Without this driver, subsequent
reboots will fail.
Note – If you accidentally choose Auto Reboot, you can still install the HBA
driver prior to reboot. From an ok prompt, you can use the boot net -s
command to boot from the network into single-user mode and then install the
driver.
3. Use the df command to verify the following:
■ The product install directory is mounted on /cdrom from the network install
server.