4-8 Sun Blade T6320 Server Module Service Manual • June 2009
Caution – The cable dongle is for temporary connections only. The cable dongle has
not been evaluated for electromagnetic compatibility (EMC). The cable dongle or
server module connectors could be damaged by rack doors or other impacts.
Remove the cable dongle during normal system operation.
Note – If you are using the older 4-cable dongle (UCP-4), do not use the RJ-45
connector with the Sun Blade T6320 server module. Use the DB-9 connector for serial
connections.
4. Open the ejector levers (
FIGURE 4-3).
FIGURE 4-3 Removing the Sun Blade T6320 Server Module From the Chassis
5. While pinching the release latches, slowly pull the server module forward
until the slide rails latch.