Filter
Top Products
4-10 Sun Blade T6320 Server Module Service Manual • June 2009
FIGURE 4-5 Antistatic Mat and Wrist Strap
8. While pressing the top cover release button, slide the cover toward the rear of
the server module about an inch (2.5 mm).
9. Lift the cover off the chassis.
4.3 Removing and Replacing DIMMs
This section describes how to remove and replace DIMMs.
4.3.1 Removing the DIMMs
LEDs indicate if a DIMM requires replacement.
■ If the system is still powered on and installed in the chassis, see Section 2.2,
“Memory Configuration and Fault Handling” on page 2-7 to determine if a
DIMM requires replacement.
■ If the server module is powered off, you can remove the server module from the
chassis. Pressing the DIMM Locate button illuminates and LED next to the faulty
DIMMs (
FIGURE 4-6).
Caution – Ensure that you follow antistatic practices as described in Section 4.1.2,
“Electrostatic Discharge Safety” on page 4-2.