Filter
Top Products
2-40 Sun Blade T6320 Server Module Service Manual • June 2009
2.6.4.2 Clearing Faults With the ILOM CLI
1. At the ILOM prompt, type the show /SP/faultmgmt command to identify
POST detected faults.
POST detected faults are distinguished from other faults by the text:
deemed faulty and disabled, and no UUID number is reported.
For example:
-> show /SP/faultmgmt
■ If no fault is reported, you do not need to do anything else. Do not perform the
subsequent steps.
■ If a fault is detected, continue with Step 2.
2. Type the set component_state=enabled command to clear the fault and
remove the component from the ASR blacklist.
Type the FRU name that was reported in the fault in the previous step.
This example shows how to change directory to thread P32 on the CPU and
enable it.
The fault is cleared and should not show up when you type the show
/SP/faultmgmt command. Additionally, the Service Action Required LED is no
longer illuminated.
3. Reboot the server module.
You must reboot the server module for the enablecomponent command to take
effect.
-> cd /SYS/MB/CMP0/P32
/SYS/MB/CMP0/P32
-> show
/SYS/MB/CMP0/P32
Targets:
Properties:
type = CPU thread
component_state = Disabled
Commands:
cd
show
-> set component_state=enabled
Set ’component_state’ to ’enabled’