Filter
Top Products
Chapter 4 Replacing Cold-Swappable Components 4-21
1. Place your fingers under the RAID expansion module (REM), with each finger
close top the connector (
FIGURE 4-12).
2. Lift the card free from the connector.
3. Lift the REM free from the gray plastic standoff.
FIGURE 4-12 Removing the RAID Expansion Module
4.6.1 Installing the RAID 5 Expansion Module
1. Place the card under the tabs of the gray plastic standoff (FIGURE 4-13).
2. Press on the rubber button on the top of the card until the connector engages
with the connector on the motherboard (
FIGURE 4-13).