Sun Microsystems T6320 Server User Manual


 
Chapter 4 Replacing Cold-Swappable Components 4-23
2. Enter the Open Boot Prompt (OBP) and use the show-disks command to list
the current devices.
In the following example, the HBA is the first device that is listed.
Note Device paths might vary from this example, depending on which SPARC
system you are using and into which PCI-E slot the card is plugged.
3. Use the select command to select the device node for the HBA, and follow
the on-screen instructions by pressing Enter when prompted.
Note When you run this command, omit /disk from the HBA device path, as
shown in the following example.
{0} ok show-disks
a) /pci@500/pci@0/pci@9/scsi@0/disk
b) /pci@500/pci@0/pci@2/pci@0/usb@0,2/storage@5/disk
c) /pci@500/pci@0/pci@2/pci@0/usb@0,2/storage@1/disk
{0} ok select /pci@500/pci@0/pci@9/scsi@0
Waiting for AAC Controller to start: . . Started