Filter
Top Products
3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
PORTEGE A100 Maintenance Manual (960-460) 3-5
4. Select the option you want to execute on the test menu and press Enter. When you select
1- SYSTEM TEST, the following message will appear:
SYSTEM TEST XXXXXXX XXXX DIAGNOSTIC TEST VXXX
[Ctrl]+[Break] : test end
[Ctrl]+[C] : key stop
SUB-TEST : XX
PASS COUNT : XXXXX ERROR COUNT : XXXXX
WRITE DATA : XX READ DATA : XX
ADDRESS : XXXXXX STATUS : XXX
SUB-TEST MENU :
01 - ROM checksum
02 – SET UUID
03 -
04 – Fan ON/OFF
05 -
06 - Quick charge
07 - DMI read
08 - DMI write
09 –
10 - Temperature surveillance test
11 - BT/W-LAN switch test
12 - Battery F/W test
13 – Option battery F/W test
99 - Exit to DIAGNOSTIC TEST MENU
Note: The menu displayed on your computer may be slightly different from the one
shown above.
5. Select the subtest number to execute from the subtest menu and press Enter. The following
message will appear:
TEST LOOP : YES (or NO)
ERROR STOP : YES (or NO)
Use the right and left arrow keys to move the cursor to the desired option.
Selecting YES in TEST LOOP increases the pass counter by one each time the test cycle
ends, and restarts the test cycle.