Filter
Top Products
4.22 LCD unit / FL inverter 4 Replacement Procedures
PORTEGE A100 Maintenance Manual (960-460) 4-47
6. Disconnect the LCD cable and remove the LCD unit.
LCD
LCD cable
Soft cloth
Glass tape
Figure 4-37 Removing the LCD unit
Installing a LCD unit / FL inverter
To install a LCD unit and FL inverter, perform the following procedure. (See Figure 4-33 to
4-37.)
1. Connect the LCD cable to the connector on the back of the LCD and fix with the
glass tape.
2. Put the LCD unit on the LCD with the guide hole into the guide and fix with the
following screws.
• M2×4Z BIND screw x4
3. Connect the two cables to the connector of the FL inverter.
4. Set the FL inverter and fix it with the following screw.
• M2×4Z BIND screw x1
5. Mount the display mask and push to lock all the latches.
6. Fix the display mask with the following screws and stick the mask seals.
• M2×4Z BIND screw x2