Filter
Top Products
1039
Parameters value: Bandwidth reference value in Mbps, ranging from 1 to 2147483648.
Description Use the
bandwidth-reference command to set the bandwidth reference value
for calculating link cost.
Use the
undo bandwidth-reference command to restore the default.
By default, the reference value is 100 Mbps.
In the case no interface cost is specified in interface view or system view and
automatic cost calculation is enabled:
■ When the cost style is wide or wide-compatible, IS-IS automatically
calculates the interface cost based on the interface bandwidth, using the
formula: interface cost = bandwidth reference value/interface bandwidth, and
the maximum calculated cost is 16777214.
■ When the cost style is narrow, narrow-compatible, or compatible, if the
interface is a loopback interface, the cost value is 0; otherwise, the cost value is
automatically calculated as follows: if the interface bandwidth is in the range of
1 M to 10 M, the interface cost is 60; if the interface bandwidth is in the range
of 11 M to 100 M, the interface cost is 50; if the interface bandwidth is in the
range of 101 M to 155 M, the interface cost is 40; if the interface bandwidth is
in the range of 156 M to 622 M, the interface cost is 30; if the interface
bandwidth is in the range of 623 M to 2500 M, the interface cost is 20, and
the default interface cost of 10 is used for any other bandwidths.
Related commands: auto cost enable.
Examples # Configure the bandwidth reference of IS-IS process 1 as 200 Mbps.
<Sysname> system-view
[Sysname] isis
[Sysname-isis-1] bandwidth-reference 200
circuit-cost
Syntax circuit-cost value [ level-1 | level-2 ]
undo circuit-cost [ level-1 | level-2 ]
View IS-IS view
Parameters value: Specifies the global link cost value. The value range varies with cost types.
■ For types narrow, narrow-compatible and compatible: The cost value
ranges from 0 to 63.
■ For types wide and wide-compatible: The cost value ranges from 0 to
16777215.
level-1: Applies the link cost to Level-1.