Filter
Top Products
2657
Description Use the group-b enable command to enable R2 signaling to use Group B signals
to complete registers exchange.
Use the
undo group-b enable command to disable R2 signaling from using
Group B signals to complete registers exchange.
By default, Group B signals are used to complete registers exchange.
This command applies to R2 signaling only.
You may need to configure the undo form of this command to accommodate to
the R2 interregister signaling in some countries where Group B signals is not
supported or cannot be interpreted correctly.
Related command: register-value req-switch-groupb.
Example # Adopt Group B signals to complete registers exchange.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 0
[Sysname-cas1/0:0] group-b enable
line
Syntax line slot-number:{ ts-set-number | 15 | 23 }
undo line
View POTS voice entity view
Parameter slot-number: Number of the E1/T1 interface corresponding to a subscriber line.
ts-set-number: Number of the TS group created on the E1/T1 interface.
15: Indicates that the POTS voice entity is to be associated with an E1 voice ISDN
PRI interface.
23: Indicates that the POTS voice entity is to be associated with a T1 voice ISDN PRI
interface.
Description Use the line command to configure the binding between a POTS entity and a
logical voice subscriber line.
Use the
undo line command to remove the binding.
By default, there is no binding between a POTS entity and a logical voice
subscriber line.
This command applies to both E1 and T1 voice.