Filter
Top Products
2384 CHAPTER 158: FTP CLIENT CONFIGURATION COMMANDS
Description Use the open command to log onto the IPv4 FTP server under FTP client view.
At login, you will be asked to enter the username and password for accessing the
FTP server. If your input is correct, the login succeeds; otherwise, it fails.
Related command: close
Example # In FTP client view, log onto the FTP server with the IP address of 192.168.1.50..
<Sysname> ftp
[ftp] open 192.168.1.50
Trying 192.168.1.50 ...
Press CTRL+K to abort
Connected to 192.168.1.50.
220 FTP service ready.
User(192.168.1.50:(none)):aa
331 Password required for aa.
Password:
230 User logged in.
[ftp]
open ipv6
Syntax open ipv6 server-address [ service-port ] [ -i interface-type interface-number ]
View FTP client view
Parameter server-address: IP address or host name of the remote FTP server.
service-port: Port number of the remote FTP server, in the range 0 to 65535. The
default value is 21.
-i interface-type interface-number: Specifies the egress interface by it type and
number. This parameter can be used only in case that the FTP server address is the
link local address and the specified egress interface must have a link local address
(For the configuration of link local address, see “IPv6 Basics Configuration
Commands” on page 829).
Description Use the
open ipv6 command to log onto IPv6 FTP server in FTP client view.
At login, you will be asked to enter the username and password for accessing the
FTP server. If your input is correct, the login succeeds; otherwise, it fails.
Related command: close
Example # Log onto the FTP server (with IPv6 address 3000::200) in FTP client view.
<Sysname> ftp
[ftp] open ipv6 3000::200
Trying 3000::200 ...
Press CTRL+K to abort