![](http://pdfasset.owneriq.net/1/8b/18b1e1e7-4363-4706-bb94-6eba3a993996/18b1e1e7-4363-4706-bb94-6eba3a993996-bg12f.png)
303
Parameter vt-number: Number of the virtual template (VT) interface corresponding to a
PPPoA map.
Description Use the map ppp command to create a PPPoA map on the PVC.
Use the undo map ppp command to delete the map.
By default, no mapping is configured.
Before this command is used, the VT must have already been created.
Example The following example demonstrates a complete process of PPPoA configuration.
# Create a VT interface numbered 10, and assign it an IP address.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] ip address 202.38.160.1 255.255.255.0
[Sysname-Virtual-Template10] quit
# Create PVC 1/101 on interface Atm1/0.
[Sysname] interface atm 1/0
[Sysname-Atm1/0] pvc 1/101
# Create a PPPoA map using the VT interface created.
[Sysname-atm-pvc-Atm1/0-1/101] map ppp virtual-template 10
mtu
Syntax mtu mtu-number
undo mtu
View Interface view
Parameter mtu-number: MTU size on ATM interface, in range of 128 to 2000 bytes.
Description Use the
mtu command to set the size of maximum transmission unit (MTU) on
ATM interface.
Use the
undo mtu command to restore the default.
By default, the MTU of an ATM interface is 1,500 bytes.
The MTU only influences the packet assembly and disassembly at IP layer at the
ATM interface. Due to the limit of QoS queue length (for example, the default
length of the FIFO queue is 75), MTU which is too small may cause numerous
fragments and thus be dropped by the QoS queue. In this case, the length of the
QoS queue can be increased appropriately. The default queue dispatching