Filter
Top Products
592 CHAPTER 37: ISDN CONFIGURATION COMMANDS
start: Starts counting.
stop: Stops counting.
Description Use the
isdn statistics command to have the system make statistics on the
information received and transmitted at an ISDN interface.
By default, no statistics is made on the information transmitted and received at
interfaces.
Use the
isdn statistics start command in the view of an interface to start
making statistics on the messages received and transmitted at the interface.
Use the
isdn statistics display command to view the statistic information.
Use the isdn statistics continue command to continue the effort in making
statistics.
Use the
isdn statistics display flow command to view the statistics in the form
of flow.
Use the
isdn statistics stop command to stop making statistics.
Use the isdn statistics clear to clear the statistic information.
Example # Start counting incoming and outgoing messages on CE1/PRI interface serial
1/0:15.
<Sysname> system-view
[Sysname] interface serial1/0:15
[Sysname-Serial1/0:15] isdn statistics start
# After a while, stop counting incoming and outgoing messages on CE1/PRI
interface serial 1/0:15.
[Sysname-Serial1/0:15] isdn statistics stop
# Display statistics about the received and sent messages forCE1/PRI interface
serial 1/0:15.
[Sysname-Serial1/0:15] isdn statistics display
Q.931 message received and sent out on current port:
CALL_PROC Send(0) Recv(6)
SETUP Send(6) Recv(13)
CONN Send(13) Recv(5)
SETUP_ACK Send(0) Recv(6)
CONNECT_ACK Send(5) Recv(13)
DISCONNECT Send(3) Recv(16)
RELEASE Send(1) Recv(18)
RELEASE_COM Send(18) Recv(1)
isdn two-tei
Syntax isdn two-tei