Filter
Top Products
372 CHAPTER 22: FRAME RELAY CONFIGURATION COMMANDS
Description Use the display fr compress command to display the statistics information
about frame relay compression. If no interface is specified, the DLCI statistics
information for all interfaces is displayed.
Related commands: fr compression frf9.
Example # Display the frame relay compression statistics information of FRF.9 stac.
<Sysname> display fr compress
Serial2/0
-DLCI:22
enable frame-relay compression
uncompressed bytes send/receive : 0/0
compressed bytes send/receive : 0/0
1 min avg ratio send/receive : 0.000/0.000
5 min avg ratio send/receive : 0.000/0.000
display fr dlci-switch
Syntax display fr dlci-switch [ interface interface-type interface-number ]
View Any view
Parameter interface interface-type interface-number: Specifies an interface by its type and
number.
Description Use the
display fr dlci-switch command to display the information about the
configured FR switching to check if the frame relay switching of a user is correctly
configured.
The interface specified by interface-type interface-number can only be a main
interface. If no interface is specified, this command displays the information about
all the main interfaces.
Example # Display the information of the configured FR switching.
<Sysname> display fr dlci-switch
Frame relay switch statistics
Status Interface(Dlci) <----------> Interface(Dlci)
Inactive Serial2/1(100) Serial2/0(300)
Table 39 Description on the fields of the display fr compress command
Field Description
enable frame-relay compression Frame relay compression is enabled
uncompressed bytes send/receive Size of the uncompressed data transmitted
/received (in bytes)
compressed bytes send/receive Size of the compressed data transmitted/received
(in bytes)
1 min avg ratio send/receive Average transmission/receiving rate during the
latest one minute
5 min avg ratio send/receive Average transmission/receiving rate during the
latest five minutes