Filter
Top Products
1516 CHAPTER 95: MPLS BASICS CONFIGURATION COMMANDS
n
For information about FRR, refer to “MPLS TE Configuration Commands” on page
1565.
display mpls label
Syntax display mpls label { label-value1 [ to label-value2 ] | all }
View Any view
Parameter all: Specifies all labels.
label-value1: Specifies a label or, when used with the label-value2 argument, the
start label of a range of labels. The value of this argument ranges from 16 to
8191.
to label-value2: End label of a range of labels, in the range 16 to 8191.
all: Specifies all labels.
Description Use the
display mpls label command to display the status of one or more
specified or all labels.
Example # Display the status of a specified label.
<Sysname> display mpls label 1280
Label alloc state: ’.’ means not used, ’$’ means used
-------------Dynamic Label--------------------------------
1280:.
# Display the status of all labels.
<Sysname> display mpls label all
---------------------------------------------------------------------
Label alloc state: ’.’ means not used, ’$’ means used
------------------------Static Label---------------------------------
16:.... ........ ........ ........ ........ ........ ........ ........
976:........ ........ ........ ........ ........ ........
------------------------Dynamic Label--------------------------------
1024: $ $$...... ........ ........ ........ ........ ........ ........
1088:.. ........ ........ ........ ........ ........ ........ ........
Status Status of the interface
TE Attr/TE Attribute Whether TE is enabled on the interface
LSPCount Number of LSPs on the interface
CR-LSPCount Number of CR-LSPs on the interface
FRR Whether FRR is enabled on the interface. If FRR is enabled, the
output will also include the bound tunnels.
Table 368 Description on the fields of the display mpls interface command
Field Description