Filter
Top Products
2667
min: Selects the timeslot with the smallest number from currently available
timeslots.
minpoll: Selects the timeslot with the lowest number from available timeslots in
the first timeslot polling; in later pollings, selects in ascending order timeslots with
numbers greater than the one picked out in the previous polling. Suppose TS1 and
TS3 are not available. In the first polling, TS2 will be picked out for use and in the
next polling, TS4.
Description Use the
select-mode command to set the E1 trunk routing mode.
Use the undo select-mode command to restore the default.
By default, the timeslot with the smallest number is selected.
Related command: cas and trunk-direction.
Example # Set the trunk routing mode for TS group 5 to max on interface E1 1/0.
<Sysname> system-view
[Sysname] controller e1 1/0
[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2
[Sysname-e1 1/0] cas 5
[Sysname-cas1/0:5] select-mode max
sendring ringbusy enable
Syntax sendring ringbusy enable
undo sendring ringbusy enable
View R2 CAS view
Parameter None
Description Use the
sendring ringbusy enable command to enable the terminating point
to send busy tones to calling subscribers.
Use the
undo sendring ringbusy enable command to disable the terminating
point from sending busy tones to calling subscribers.
By default, the terminating point sends busy tones to calling subscribers.
This command applies to R2 signaling only.
Related command: timer ring.
Example # On TS group 5 on interface E1 1/0 configure the terminating point to send
ringback tone to the calling side.