Filter
Top Products
1553
# Set the targeted Keepalive timer for remote sessions to 1,000 seconds.
<Sysname> System-view
[Sysname] mpls ldp remote-peer BJI
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
[Sysname-mpls-ldp-remote-bji] mpls ldp timer keepalive-hold 1000
mpls ldp transport-address
Syntax mpls ldp transport-address { interface-type interface-number | interface }
undo mpls ldp transport-address
View Interface view/MPLS LDP remote peer view
Parameter interface-type interface-number: Specifies an interface by its type and number,
making LDP use the address of this interface as the TCP transport address.
interface: Specifies that LDP use the IP address of the current interface as the TCP
transport address. This keyword is available only in interface view.
Description Use the
mpls ldp transport-address command to configure the LDP transport
addresses.
Use the
undo mpls ldp transport-address command to restore the defaults.
By default, the transport addresses are both the MPLS LSR ID.
In interface view, you configure the link Hello transport address; in MPLS LDP
remote peer view, you configure the targeted Hello transport address.
Example # On interface Ethernet 1/0, configure the link Hello transport address for local
sessions as the IP address of the current interface.
<Sysname> System-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] mpls
[Sysname-Ethernet1/0] mpls ldp
[Sysname-Ethernet1/0] mpls ldp transport-address interface
# Configure the targeted Hello transport address for remote sessions to be the IP
address of interface Ethernet 1/0.
[Sysname] mpls ldp remote-peer bji
[Sysname-mpls-ldp-remote-bji] remote-ip 3.3.3.3
[Sysname-mpls-ldp-remote-bji] mpls ldp transport-address ethernet 1/0
mpls lsr-id
Syntax mpls lsr-id lsr-id
undo mpls lsr-id