Filter
Top Products
2572 CHAPTER 173: VOIP CONFIGURATION COMMANDS
Parameter send-dtmf milliseconds: Specifies a delay (in milliseconds) before the originating
side sends DTMF signals in the immediate start mode. The value ranges from 50 to
5,000.
Description Use the
delay send-dtmf command to configure a delay before the originating
side sends DTMF signals in the immediate start mode.
Use the
undo delay send-dtmf command to restore the default.
By default, the delay before the originating side sends DTMF signals in the
immediate start mode is 300 milliseconds.
Related command: em-signal.
Example # Set the delay before the originating side sends DTMF signals in the immediate
start mode to 3,000 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1] delay send-dtmf 3000
delay send-wink
Syntax delay send-wink milliseconds
undo delay send-wink
View E&M voice subscriber line view
Parameter send-wink milliseconds: Specifies an interval (in milliseconds) from when the
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode. The value ranges from 100 to 5,000.
Description Use the
delay send-wink command to configure an interval from when the
terminating side receives a seizure signal to when it sends a wink signal in the
wink start mode.
Use the
undo delay send-wink command to restore the default.
By default, the interval from when the terminating side receives a seizure signal to
when it sends a wink signal is 200 milliseconds in the wink start mode.
Related command: em-signal.
Example # Set the interval from when the terminating side receives a seizure signal to when
it sends a wink signal in the wink start mode to 700 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0