Filter
Top Products
172
IPX CONFIGURATION COMMANDS
display ipx interface
Syntax display ipx interface [ interface-type interface-number ]
View Any view
Parameter interface-type interface-number: Displays the IPX information of an interface.
Description Use the
display ipx interface command to display IPX information on a
specified interface.
If no interface is specified, information about all IPX interfaces will be displayed.
Example # Display IPX information on the interface Ethernet 1/1.
<Sysname> display ipx interface ethernet 1/1
Ethernet1/1 is up
IPX address is 1.0000-5e19-1d01 [up]
SAP is enabled
Split horizon is enabled
Update change only is disabled
Forwarding of IPX type 20 propagation packet is disabled
Delay of this IPX interface, in ticks is 1
SAP GNS response is enabled
RIP packet maximum size is 432 bytes
SAP packet maximum size is 480 bytes
IPX encapsulation is Netware 802.3
0 received, 2 sent
0 bytes received, 74 bytes sent
0 RIP received, 1 RIP sent, 0 RIP discarded
0 RIP specific requests received, 0 RIP specific responses sent
0 RIP general requests received, 0 RIP general responses sent
0 SAP received, 0 SAP sent, 0 SAP discarded
0 SAP requests received, 0 SAP responses sent
Table 658 Description on the fields of the display ipx interface command
Field Description
Ethernet1/1 is up Ethernet1/1 is up
IPX address The IPX network number and node number
of the current interface
[down] / [up] IPX protocol status
SAP is enabled SAP is enabled
Split horizon is enabled Split horizon is enabled