Filter
Top Products
1500 CHAPTER 93: IPV6 PIM CONFIGURATION COMMANDS
Parameter interval: State refresh interval in seconds, with an effective range of 1 to 255.
Description Use the
state-refresh-interval command to configure the interval between
state refresh messages.
Use the
undo state-refresh-interval command to restore the default setting.
By default, the state refresh interval is 60 seconds.
Related command: pim ipv6 state-refresh-capable, state-refresh-rate-limit (IPv6 PIM view), and
state-refresh-hoplimit.
Example # Set the state refresh interval to 70 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-interval 70
state-refresh-rate-limit (IPv6 PIM view)
Syntax state-refresh-rate-limit interval
undo state-refresh-rate-limit
View IPv6 PIM view
Parameter interval: Time to wait before receiving a new refresh message, in seconds and with
an effective range of 1 to 65535.
Description Use the
state-refresh-rate-limit command to configure the time the router
must wait before receiving a new state refresh message.
Use the
undo state-refresh-rate-limit command to restore the default setting.
By default, the device waits 30 seconds before receiving a new state refresh
message.
Related command: pim ipv6 state-refresh-capable, state-refresh-interval (IPv6 PIM view), and
state-refresh-hoplimit.
Example # Configure the device to wait 45 seconds before receiving a new state refresh
message.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] state-refresh-rate-limit 45
static-rp (IPv6 PIM view)
Syntax static-rp ipv6-rp-address [ acl6-number ] [ preferred ]