Filter
Top Products
1050 CHAPTER 74: IS-IS CONFIGURATION COMMANDS
View Any view
Parameters verbose: When this parameter is used, the area address advertised in a neighbor’s
Hello packet will be displayed. Otherwise the system displays only the summary
information.
process-id: Specifies an IS-IS process ID, in the range of 1 to 65535.
vpn-instance-name: Specifies a VPN instance name, in the range of 1 to 31
characters.
Description Use the
display isis peer command to display IS-IS neighbor information.
Besides all the information displayed using the display isis peer command, the
display isis peer verbose command displays neighbor area address, hold time of
Up state and direct interface’s IP address.
Examples # Display detailed IS-IS neighbor information.
<Sysname> display isis peer verbose
Peer information for ISIS(1)
----------------------------
System Id: 0000.0000.0003
Interface: Ethernet1/0 Circuit Id: 0000.0000.0003.01
State: Up HoldTime: 8s Type: L1(L1L2) PRI: 64
Area Address(es):10
Peer IP Address(es): 192.168.0.3
Uptime: 00:14:03
Adj Protocol: IPV4
display isis route
Syntax display isis route [ ipv4 ] [ [ level-1 | level-2 ] | verbose ] * [ process-id | vpn-instance
vpn-instance-name ]
View Any view
Table 239 Description on the fields of the display isis peer command
Field Description
System Id System ID
Interface Interface connecting to the neighbor
Circuit Id Circuit ID
State State
HoldTime Holdtime
Type Type of the neighbor
PRI DIS Priority
Area Address(es) The neighbor’s area address
Peer IP Address(es) Interface IP address of the neighbor
Uptime Time being up
Adj Protocol Adjacency protocol