Filter
Top Products
1960 CHAPTER 128: RADIUS CONFIGURATION COMMANDS
Related command: key (RADIUS scheme view), radius scheme, state.
Example # Set the IP address of the primary authentication/authorization server for RADIUS
scheme radius1 to 10.110.1.1 and the UDP port of the server to 1812.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] primary authentication 10.110.1.1 1812
radius client
Syntax radius client enable
undo radius client
View System view
Parameter None
Description Use the
radius client enable command to enable the listening port of the
RADIUS client.
Use the
undo radius client command to disable the listening port of the
RADIUS client.
By default, the listening port is enabled.
Note that when the listening port of the RADIUS client is disabled:
■ The RADIUS client can either accept authentication, authorization or
accounting requests or process timer messages. However, it fails to transmit
and receive packets to and from the RADIUS server.
■ The end account packets of online users cannot be sent out and buffered. This
may cause that the RADIUS server still has the user record after a user goes
offline for a period of time.
■ The authentication, authorization and accounting turn to the local scheme
after the RADIUS request fails if the RADIUS scheme and the local
authentication, authorization and accounting scheme are configured.
■ The buffered accounting packets cannot be sent out and will be deleted from
the buffer when the configured maximum number of attempts is reached.
Example # Enable the listening port of the RADIUS client.
<Sysname> system-view
[Sysname] radius client enable
radius nas-ip
Syntax radius nas-ip ip-address