Filter
Top Products
PinPoint EDGE/GPRS - User Guide, version 2.32 94
AT Commands: PassThru
\APASSTHRU
Caution: This mode is not available through the remote AT telnet server. You will need to
connect to the PinPoint with it connected directly to your computer.
Sets the modem operation to pass through mode. This mode will pass any characters received
on the serial port directly to the internal hardware module and output any characters from the
internal hardware module out the serial port. This allows direct access/configuration of the
hardware module. Once this mode is entered, the unit must be physically reset to return to nor
-
mal operation.
This command is not available in Wireless Ace.
Note: It may take up to 30 seconds for the hardware module to respond after CONNECT is
output.