Airlink PinPoint EDGE/GPRS Network Router User Manual


 
PinPoint EDGE/GPRS - User Guide, version 2.32 108
AT Commands: PinPoint
*PPFLUSHONEVT=n
*PPGPSDATUM=n
*PPGPSSENTENCES=n
*PPGPSR=n
*PPIGNOREIP=n
*PPINPUTEVT=n
Flushes store and forward buffer when an input event (DTR/RTS) occurs.
n=0 : Disable
n=1 : Enable
Specifies the GPS datum to use for position reports. For accurate results, this value should
match the datum used by receiving mapping application.
n=0 : WGS84
n=92 : NAD27
n=115 : NAD83
Note: This command may not be available for your PinPoint. This requires spe-
cific internal hardware as well as a recent version of ALEOS.
Specifies the NMEA sentences to display in the NMEA GPS Report.
n=0-65535 (hex)
GPS report type.
n=0 : Use legacy reports specified in *MF value. Note: Must also have *PPDEVID=0.
n=0x11 : Standard GPS Report
n=0x12 : Standard GPS Report + UTC Date
n=0x13: Standard GPS Report + UTC Date + RF data
n=0xD0 : Xora reports.
n=0xE0 : GGA and VTG NMEA reports
n=0xE1: GGA, VTG and RMC NMEA reports
n=0xF0 : TAIP reports .
n=0xF1 : Compact TAIP data
When enabled, ignore ATS Server IP (*PPIP) updates in RAP.
n=0 : Use ATS Server IP updates.
n=1 : Ignore ATS Server IP updates.
Enable sending input changes as events (different report types).
n=0 : Disabled
n=1 : Enabled Activée