Filter
Top Products
PinPoint EDGE/GPRS - User Guide, version 2.32 102
AT Commands: Friends
Friends Mode can limit access to the PinPoint from Your Wireless Service Provider’s network and
the Internet. Friends Mode is a basic firewall.
FIGURE 1. Common : Friends
FM=n
Fn=[d.d.d.d]
Friends
Note: Friends mode does not block any traffic from the cellular network, wanted or
not. Friends Mode will only prevent the
PinPoint from receiving data from those
not on the Friends List. It does not prevent data from traversing the network to the
modem which may billable traffic.
Caution: If you are using Friends Mode you will not be able to use Wireless Ace
remotely or Telnet to the modem unless you are contacting the modem from one of
the configured IP addresses.
Friends Mode - Only allow specified IPs to access the PinPoint.
n=0 : Disable Friends mode
n=1 : Enable Friends mode - Only packets from friends will be accepted (see below); packets from other
IP addresses are ignored.
Friends mode IP address.
n=0 - 9 Friends list index .
d.d.d.d =IP address