Filter
Top Products
PinPoint EDGE/GPRS - User Guide, version 2.32 99
AT Commands: Other
*SNMPTRAPDEST=host/[port]
*SNTP=n
*SNTPADDR=[d.d.d.d][name]
*TELNETTIMEOUT=n
*TPORT=n
n=0 : No security required. SNMPv2c and SNMPv3 communications are allowed.
n=1 : Authentication equivalent to “authNoPriv” setting in SNMPv3. SNMPv3 is required to do authen-
tication, SNMPv2c transmissions will be silently discarded.
n=2 : Authentication and encryption, equivalent to “authPriv”' setting in SNMPv3. SNMPv3 is required
to do authentication and encryption, SNMPv2c and SNMPv3 authNoPriv transmissions will be silently
discarded. Messages are both authenticated and encrypted to prevent a hacker from viewing its contents.
Controls destination for SNMP Trap messages.
host=IP address
port=TCP port
If port is 0 or host is empty, traps are disabled.
Traps are sent out according to the SNMP security level (i.e. if the security level is 2, traps will
be authenticated and encrypted). Currently, the only trap that can be generated is linkup.
Enables daily SNTP update of the system time.
n=0 : Off
n=1 : On
SNTP Server IP address, or fully-qualified domain name, to use if *SNTP=1.
d.d.d.d=IP
name=domain name
If blank, time.nist.gov is used.
Telnet port inactivity time out.
n=minutes
By default, this value is set to close the AT telnet connection if no data is received for 2 min-
utes.
Sets or queries the port used for the AT Telnet server. If 0 is specified, the AT Telnet server will
be disabled. The default value is 2332. .
n=1-65535
n=0 : Disabled.