Filter
Top Products
PinPoint EDGE/GPRS - User Guide, version 2.32 76
AT Commands: Serial
This group includes commands specific to the serial port.
+++
Serial
The commands displayed in Wireless Ace and the results of those commands depends on the
model of the modem. Some of the commands in this section, as noted, are not available in Wire
-
less Ace. Many of the commands not available with Wireless Ace require PassThru mode to use.
FIGURE 1. Common : Serial
Note: This command is not proceeded by AT nor does it require a carriage return
(enter).
There must be an idle time (set by S50) on the serial port before and after this com-
mand.
The “+” is ASCII 0x2B.
AT Escape sequence.
If the PinPoint is in a data mode (any mode other than PassThru), this command causes the modem to
re-enter AT command mode.
Cannot be configured in Wireless Ace.
Note: This command does nothing if DAE=1.