Filter
Top Products
System Restarts
Issue 4 August 2002
5-7
System Restarts
The current service state for an XMOBILE station is preserved for system restarts
at levels 1 and 2.
XMOBILE station service states are not saved for system restart levels 3, 4, and 5
and the service state for all administered XMOBILE stations is reset to the
In-Service state after the switch is successfully rebooted following the restarts.
Status Station Command
status station <XMOBILE extension>
The status station maintenance command is used to view the service state
of the XMOBILE station.
The EC500 state is shown on the status station
<XMOBILE extension> screen.
■ When EC500 is disabled ** (two asterisks) are displayed in the CF
Destination Ext:
field and the EC500 status field displays the value
disabled.
NOTE:
The ** are shown only for bridged XMOBILE extensions. If using the
EC500 with the UCC Scheduler to disable the XMOBILE, then you
will see the primary extension number instead of the **.
■ When EC500 is enabled, the CF Destination Ext: field is blank and
the
EC500 status field displays the value enabled.
■ When a new EC500 XMOBILE station is added, the station comes up in the
disabled state.