Barco HDX Projector User Manual


 
13. Projector Control
IP
Internet Protocol. The network layer of TCP/IP. Required for communication with the internet.
Subnet mask
A number that is used to identify a subnetwork so that IP addresses can be shared on a local area network.
Default Gateway
A router that serves as an entry point into and exit point out of a network. For example, a local network (LAN) may
need a gateway to connect it to a wide area network (WAN) or to the Internet.
MAC address
Media Access Control address. Unique hardware number, used in combination with the IP-address to connect to the
network (LAN or WAN).
What should be set up for an Ethernet address?
2 ways can be used to assign an address:
use the DHCP setting so that an automatic address will be assigned.
Assign manually an IP address, Net-mask (subnet-mask), (default) gateway address.
- Set the IP-Address eld to the desired value. This must NOT be 0.0.0.0 for static IP-Address assignment. The IP address
identies a projector’s location on the network in the same way a street address identies a h
ouse on a city block. Just as
a street address must identify a unique residence, an IP address must be globally unique and have a uniform format.
- Set the Subnet-Mask as appropriate for the local subnet.
- Set the Default-Gateway to the IP-Address of the local router (MUST be on the local subnet!) on the same network as this
projector that is used to forward trafc to destinations beyond the local network. This must not be 0.0.0.0. If there is no
router on the projector’s local subnet then just set this eld to any IP-Address on the subnet.
13.5.2 Wired DHCP set up
How to set up
1. Press Menu to activate the menus and select Projector Control Network.
Image 13-15
Main menu, projector control
Image 13-16
Projector control, network
224 R5905032 HDX SERIES 02/03/2015