Filter
Top Products
Section 2: Installation and Setup
2-10 RPMSP & CSP70-D100U User’s Manual
Plug the line cord to the AC receptacle located in the bottom left corner of the Dual
Lamp Module (DLM), and the 3-pronged end into a grounded AC outlet. The input
voltage to the projector must be capable of 100 - 240 VAC. (See also Section 6 –
Specifications for complete details on all power requirements.)
Use the approved North American-rated line cord supplied with the projector. If you
are connecting to an area outside of North America make sure you are using an
appropriately rated line cord.
Always power down the projector before unplugging the AC line cord. Wait
approximatley10 minutes for the lamps to cool sufficiently before unplugging the
projector.
WARNINGS
Do not attempt operation if the AC supply and cord are
not within the specified voltage and power range.
2.4 Power
Connection