Filter
Top Products
Section 4: Maintenance
4-2 RPMSP & CSP70-D100U User’s Manual
You will notice a significant change in the performance of the lamp when it is nearing
the end of its life. It is important that the changes in lamp performance are noted and
the number of hours the lamp has been in use is considered to effectively maintain the
continuous operation of your projector. If a lamp reaches its end of life or has failed
during operation it should be replaced as soon as possible.
WARNING
It is strongly recommended lamp replacement occur after
the projector is powered down and the lamp is cool.
Never attempt lamp replacement soon after shutdown.
The lamp is under great pressure when hot and may
explode causing physical injury and/or property
damage. Always allow the lamp to cool completely
before handling.
During a hot swap, it is strongly recommended power be
cut to the lamp that requires replacement – this requires
switching lamp modes.
Never look or stick hands inside an empty lamp
compartment while the other lamp is still ON to prevent
injury from U.V. light and heat.
Use only the lamps specified and supplied by the
manufacturer.
Use only the attachments and/or accessories recommended by the manufacturer. Use
of others may result in the risk of fire, shock or personal injury.
Use only the AC power cord supplied by the
manufacturer. Do not attempt operation if the AC supply
is not within the specified voltage and power range.
◊ Do not set or rest items on the power cord. Locate the projector in an area where
the projector cord cannot be abused or damaged by persons walking on it or by
objects rolling over it.
◊ Operate the projector at the specified voltage only. Do not overload power outlets
and extension cords as this can result in fire or shock hazards.
◊ The projector is equipped with a three-wire plug having a third grounding pin.
This is a safety feature – if you are unable to insert the plug into an outlet contact
an electrician to have the outlet replaced. Do not defeat the safety purpose of this
grounding-type plug. NOTE: The power cord supplied with the projector is
approved for North American use only. An appropriately rated power cord with
IEC320 type plug is required for European and other countries.
Lam
p
Re
p
lacemen
t
'
Power Cord '
and Attachments