Filter
Top Products
Section 3: Operation
3-26 RPMSP & CSP70-D100U User’s Manual
• 0 IRE – Used for DVD output with “enhanced black”, SECAM, most PAL
standards, and Japanese NTSC.
•
7.5 IRE – Used for most NTSC video signals.
For some types of video, you can override the setting. The control is disabled for other
types of video (and all graphics sources). Generally, if black appears crushed when
brightness = 50, choose “0 IRE”. If black appears excessively elevated, use “7.5 IRE”.
COLOR: This slidebar adjusts the color saturation level, i.e. the amount of color in a
video image. Lower settings produce less saturated colors — for example a setting of
“0” produces a black and white image. If the color level is too high, colors will be
overpowering and unrealistic.
TINT: This slidebar adjusts the red/green color hue for true color reproduction of video
and HDTV signals connected to Input 3 or 4. For best results, adjust tint while
displaying an external test pattern—otherwise, it is recommended that tint remain at
its default setting.
DECODER LUMA DELAY: This control affects any incoming composite or S-video
signal, delaying the luma signal (intensity) in relation to the chroma (color). In the
image, increasing the luma delay will move luma (seen as a shadow where colors
overlap) to the right slightly, with colors remaining in place. Decreasing this delay
will move the shadow slightly to the left. If necessary for your current source, adjust
so that no shadows occur with adjacent colors.
Input Levels
— SUBMENU
NOTES: 1) Because the projector automatically optimizes input levels for all but the
most unusual of sources, it is recommended that only experienced users use the Input
Levels submenu. 2) Before beginning, check that overall contrast and brightness
settings are near 50 and that color temperature is properly set up on an internal
grayscale test pattern. 3) There must be at least 2 consecutive white pixels present in
the image for proper “Auto Input Level” function. Leave this control off after use.
Good RGB or input levels—
that is, the drives and
blacklevels for each of the
three colors, red, green and
blue—ensure that images
from analog sources other
than decoded video have
maximum contrast without
crushing black or white. By
default (and in an “Auto
Setup”), the projector
automatically determines the
best input levels by
monitoring image content and adjusting the controls appropriately—further
adjustment is typically not required to obtain proper blacks or whites. NOTE: This
automatic adjustment requires at least 6-12 consecutive white pixels in the image.
Without these pixels, input levels may produce skewed colors, particularly in non-
video images.
However, for a very unusual source exhibiting one or more overly high blacklevels
(typically caused by a noisy source causing blacklevel spikes), an experienced user