Filter
Top Products
Section 3: Operation
3-62 RPMSP & CSP70-D100U User’s Manual
The specific code number identifies the source of the error detected, and is
particularly useful in cases where the projector is far away. For example, the code
“27” means the lamp could not be turned on. Error codes for this projector are listed in
Table 3.5 below.
Table 3.5 Error Codes
Code Description
GENERAL
12 Software bug. Contact dealer/factory.
13 CRC error in flash ROM. Download new software.
14 Engineering-only programming is complete. Call Christie, replace TIPM.
15 Attempting to download code without being in boot mode
16 Invalid interrupt. Power off/on. If it persists, contact dealer/factory.
17 User forced system to stay in boot mode
18 Jumper for programming boot not installed
LAMP FAILURES
20 Lamp on before enabled
24 Both lamps failed
26 Lamp 1 Interlock: lamp door open, lamp not installed
27 Can’t turn lamp on
28 Lamp turned off unexpectedly
29 Lamp ballast overheated
2C Lamp 1 driver UART communication failure
2E Unable to read valid Lamp ID
31 Lamp 2 not installed
32 Unable to turn Lamp 2 on
33 Lamp 2 shut off unexpectedly
36 Lamp 2 driver failure
POWER AND COOLING
4C Projector shutdown due to critical error
51 TIPM fan failed (Fan 1)
53 Lamp 1 fan failed (Fan 3)
54 Lamp 2 fan failed (Fan 4)
55 DMD fan failed (Fan 5)
56 Optional auxiliary fan failed (Fan 6)
TIPM (Image Processor)
60 Boot code CRC failed
61 Unable to program DigMux PLD
62 Unable to program Control PLD
63 Unable to program BUBKS PLD
64 Unrecognized ROM type
65 Write to flash ROM failed
66 TIPM failure
67 Downloaded code will not fit
68 Scaler communication problem
BUILT-IN KEYPAD
70 Unable to access EEPROM on the built-in keypad
71 EEPROM memory re-initialization on the built-in keypad
PANEL DRIVER AND FORMATTER
80 Unrecognized Panel Driver
81 Unable to program device on Panel Driver
82 TI flash download failure
83 TI flash download failure
84 TI flash download failure
85 TI-I2C write failure
86 Communications failure
MISCELLANEOUS
A0 Unable to program the optional module
A1 Unable to power the optional module
A2 Unable to program the Dual Slot Backplane Module (DSBP)
A3 Unable to program the optional Post Processing Module (Warp module)
Clear system errors with
Exi t
Exi t
. If necessary, try resetting the projector by powering it off and on
again (cooling if necessary). For detailed information, monitor the RS232 IN port. Contact dealer/factory
if error persists. Codes omitted from this table should not appear in your projector.