Filter
Top Products
Chapter 3 Installing the Wide Area Application Engine
Connecting Cables
3-12
Cisco Wide Area Application Engine 7326 Hardware Installation Guide
OL-6831-02
Connecting Cables
To connect cables to your WAE, follow these steps:
Step 1 Power down the appliance before connecting cables to or disconnecting any
cables from the appliance.
Step 2 See the documentation that comes with your optional equipment for additional
cabling instructions. It might be easier for you to route the cables before you
install specific optional equipment.
Step 3 Cable identifiers are printed on the cables that come with the server and options.
Use these identifiers to connect the cables to the correct connectors.
Figure 3-8 shows the locations of the input and output connectors on your device.
Figure 3-8 WAE-7326 Ports and Receptacles—AC System Shown
1 Ethernet link status LED 7 Power cord connectors and LED
2 Ethernet activity LED 8 USB connectors (not supported)
3 System locator LED 9 Video connector (not supported)
TX/RX TX/RXLINK LINK
137693
3
2
1
4 5 6 7
89101112