Filter
Top Products
3-15
Cisco Wide Area Application Engine 7326 Hardware Installation Guide
OL-6831-02
Chapter 3 Installing the Wide Area Application Engine
Removing or Replacing a WAE
If you remove the last WAE from your network, you can also disable WAE support
on the router. However, this action is not necessary because leaving WAE support
enabled when there are no WAEs attached has no effect on the router’s
performance.
To replace a WAE, remove it from the network, and then install a new WAE and
configure it using the same configuration parameters (IP address, and so forth)
that you used for the removed WAE.