Filter
Top Products
2-957
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show mls
show mls
To display MLS Layer 3 packet information in the MLS-based Catalyst 6500 series switches, use the
show mls command.
show mls
Syntax Description This command has no keywords or arguments.
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines If you place the MSFC on a supervisor engine installed in slot 1, then the MSFC is recognized as
module 15. If you install the supervisor engine in slot 2, the MSFC is recognized as module 16.
This command is not supported on switches configured with the Supervisor Engine 2 with Layer 3
Switching Engine II (PFC2).
Examples These examples show the display if you enter the show mls commands on a switch configured with the
Supervisor Engine 1 with Layer 3 Switching Engine WS-F6K-PFC:
Console> show mls
Total Active MLS entries = 0
Total packets switched = 0
IP Multilayer switching enabled
IP Multilayer switching aging time = 256 seconds
IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0
IP Flow mask: Full Flow
Configured flow mask is Destination flow
Active IP MLS entries = 0
Netflow Data Export version: 8
Netflow Data Export disabled
Netflow Data Export port/host is not configured
Total packets exported = 0
MSFC ID Module XTAG MAC Vlans
--------------- ------ ---- ----------------- --------------------
52.0.03 15 1 01-10-29-8a-0c-00 1,10,123,434,121
222,666,959
IPX Multilayer switching enabled
IPX Multilayer switching aging time = 256 seconds
IPX Flow mask: Full Flow
Active IPX MLS entries = 0