Filter
Top Products
2-1033
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show port
Table 2-68 describes the possible fields (depending on the port type queried) in the show port command
output.
Table 2-68 show port Command Output Fields
Field Description
Port Module and port number.
Name Name (if configured) of the port.
Status Status of the port (connected, notconnect, connecting, standby, faulty,
inactive, shutdown, disabled, monitor, active, dot1p, untagged, inactive, or
onhook).
Vlan VLANs to which the port belongs.
Auxiliaryvlan
1
Auxiliary VLANs to which the port belongs.
Duplex Duplex setting for the port (auto, full, half).
Speed Speed setting for the port (auto, 10, 100, 1000).
Type
2
Port type (for example, 1000BASE-SX or 100BASE-FX, or T1, E1,
transcoding, conferencing, mtp, or conf bridge for voice ports).
Security Status of whether port security is enabled or disabled.
Secure-Src-Addr Secure MAC address for the security-enabled port.
Last-Src-Addr Source MAC address of the last packet received by the port.
Broadcast-Limit Broadcast threshold configured for the port.
Multicast Number of multicast packets dropped.
Unicast Number of unicast packets dropped.
Total-Drop Number of broadcast, multicast, and unicast packets dropped because the
port broadcast limit was exceeded.
Shutdown Status of whether the port was shut down because of security.
Trap Status of whether the port trap is enabled or disabled.
IfIndex Number of the ifIndex.
Broadcast-Limit Broadcast threshold configured for the port.
Broadcast-Drop Number of broadcast/multicast packets dropped because the broadcast limit
for the port was exceeded.
Errdisable Reason Reason for the port to be in errdisabled state.
Port
ErrDisableTimeout
Status of errdisable timer timeout on the port.
Action on Timeout Action that is taken on errdisable timer timeout.
Align-Err Number of frames with alignment errors (frames that do not end with an even
number of octets and have a bad CRC) received on the port.
FCS-Err Number of valid size frames with FCS errors but no framing errors.
Xmit-Err Number of transmit errors that occurred on the port (indicating that the
internal transmit buffer is full).
Rcv-Err Number of receive errors that occurred on the port (indicating that the
internal receive buffer is full).