Filter
Top Products
2-997
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show module
This example shows the display for a supervisor engine 720:
Console> show module 6
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
6 6 0 Sup 3 CPU Board Ariel --SUP3-ARIEL-- no ok
Mod Module-Name Serial-Num
--- -------------------- -----------
6 SAD04510ATR
Mod MAC-Address(es) Hw Fw Sw
--- -------------------------------------- ------ ---------- -----------------
6 00-40-0b-ff-00-00 0.202 6.1(3) 7.5(0.2)CLR
Table 2-57 describes the possible fields in the show module command output.
Table 2-57 show module Command Output Fields
Field Description
Mod Module number.
Slot Number of the slot where the module or submodule resides.
Ports Number of ports on the module.
Module-Type Module (such as 100BASE-X Ethernet).
Model Model number of the module.
Sub Status of whether a submodule is installed.
Status Status of the module. Possible status strings are ok, disable, faulty,
other, standby, error, pwr-down, and pwr-deny states
1
.
1. The pwr-down and pwr-deny states are supported by the power management feature.
Module-Name Name of the module.
Serial-Num Serial number of the module.
MAC-Address(es) MAC address or MAC address range for the module.
Hw
2
2. Hw for the supervisor engine displays the supervisor engine’s EARL hardware version.
Hardware version of the module.
Fw
3
3. Fw for the supervisor engine displays the supervisor engine’s boot version.
Firmware version of the module.
Sw Software version on the module.
Sub-Type
4
4. This field displays EARL information.
Submodule type.
Sub-Model
4
Model number of the submodule.
Sub-Serial
4
Serial number of the submodule.
Sub-Hw
4
Hardware version of the submodule.