Filter
Top Products
2-392
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set logging callhome severity
set logging callhome severity
To specify the CallHome severity level of system messages to capture, use the set logging callhome
severity command.
set logging callhome severity level
Syntax Description
Defaults The default severity level is set to 2.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines The CallHome feature is closely tied to syslog messages and their severity. When you set the CallHome
severity level, carefully consider what level of severity you require for both the syslog messages and the
CallHome messages.
For example, if you configure a very fine syslog severity level such as alerts (level 1), and a coarse
CallHome severity level such as notifications (level 5), the destination addresses will only receive alerts
and emergencies (levels 0 and 1) and not the remaining CallHome severity level notifications (levels 2,
3, and 4) you specified. To avoid this, set the CallHome severity level at the same severity level, or
higher, that you set the syslog message severity.
level Severity level of system messages to capture; severity level definitions are listed in
Table 2-15.
Table 2-13 Severity Level Definitions
Severity Level Description
0—emergencies System unusable
1—alerts Immediate action required
2—critical Critical condition
3—errors Error conditions
4—warnings Warning conditions
5—notifications Normal bug significant condition
6—informational Informational messages
7—debugging Debugging messages