Filter
Top Products
2-314
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
set errdisable-timeout
• gl2pt-stp-threshold-exceed—When Layer 2 protocol tunnel STP threshold is exceeded
• gl2pt-vtp-threshold-exceed—When Layer 2 protocol tunnel VTP threshold is exceeded
• link-rxcrc—When link-errors RX threshold is exceeded
• link-txcrc—When link-errors TX threshold is exceeded
• udld—UDLD
• other—Reasons other than the above
• all—Applies errdisable timeout for all of the above reasons
You can enable or disable errdisable timeout for each of the reasons that are listed. If you specify “other,”
all ports errdisabled by causes other than the reasons listed are enabled for errdisable timeout. If you
specify “all,” all ports errdisabled for any reason are enabled for errdisable timeout.
You can manually prevent a port from being reenabled by setting the errdisable timeout for that port to
disable using the set port errdisable-timeout mod/port disable command.
Examples This example shows how to enable an errdisable timeout due to a BPDU port-guard event:
Console> (enable) set errdisable-timeout enable bpdu-guard
Successfully enabled errdisable-timeout for bpdu-guard.
Console> (enable)
This example shows how to set an errdisable timeout interval to 450 seconds:
Console> (enable) set errdisable-timeout interval 450
Successfully set errdisable timeout to 450 seconds.
Console> (enable)
This example shows how to set an errdisable timeout for broadcast suppression events:
Console> (enable) set errdisable-timeout enable bcast-suppression
Successfully enabled errdisable timeout for bcast-suppression.
Console> (enable)
This example shows how to set an errdisable timeout for ARP inspection events:
Console> (enable) set errdisable-timeout enable arp-inspection
Successfully enabled errdisable-timeout for arp-inspection.
Console> (enable)
Related Commands set port errdisable-timeout
show errdisable-timeout