Filter
Top Products
CHAPTER 8: DEBUGGER
S5U1C63000A MANUAL EPSON 211
(S1C63 FAMILY ASSEMBLER PACKAGE)
sfl (save to flash memory)
Function
This command writes the contents of the target memory in the ICE into the flash memory.
Writing to the flash memory allows the ICE to be operated in free-run mode. Furthermore, the next
debug session can be continued immediately from the current contents in the flash memory.
Format
(1) >sfl <content> [ ... <content>] [-p]↵ (direct input mode)
(2) >sfl↵ (guidance mode)
Protect flash memory 1. yes 2. no ...? <1 | 2>↵
Write program 1. yes 2. no ...? <1 | 2>↵
data 1. yes 2. no ...? <1 | 2>↵
fog1. yes 2. no ...? <1 | 2>↵
sog 1. yes 2. no ...? <1 | 2>↵
mla 1. yes 2. no ...? <1 | 2>↵
Saving ...
>
<content>: Data type; p (program) / d (data) / f (fog) / s (sog) / m (mla)
-p: Protect option
Examples
Format (1)
>sfl p d f s m -p↵ ...Saves all contents and sets prorect.
Please wait few minutes
Save to flash memory ... done!
>
Format (2)
>sfl↵
Protect flash memory 1.yes 2.no ...? 1↵ ... Protect is set.
Write program 1.yes 2.no ...? 1↵ ... Write contents are selected.
data 1.yes 2.no ...? 1↵
fog 1.yes 2.no ...? 1↵
sog 1.yes 2.no ...? 1↵
mla 1.yes 2.no ...? 1↵
Please wait few minutes
Save to flash memory ... done!
>
∗ If you enter only the [Enter] key in the middle of guidance, the guidance is terminated and only the
area you have selected up to that time is written into the flash memory.
Notes
• If the flash memory is write-protected, an error results and memory contents are not written to the
flash memory.
Error : flash ROM is protected
The write-protect can be removed by erasing the flash memory with the efl command.