Filter
Top Products
12. In the Firmware Loader window, click Begin (see figure 61).
The Total Progress and Progress status bars show the progress of the
upload. The firmware upload to the switcher may take several minutes.
Once the status bars have progressed from 0% to 100%, and Status is listed
as Complete, the firmware loader utility resets the switcher.
12
Figure 61. Firmware Loader Screen
13. Click Exit to close the Firmware Loader.
NOTE: The firmware loader utility increases the baud rate of the serial port to
115,200 to speed up the upload process. Occasionally, the firmware loader
may be unable to return the serial port to its earlier baud rate, in which
case communications with the switcher may not be possible. If you are no
longer able to communicate with the switcher after the firmware upload
completes, see “Selecting the Rear Panel Remote Port Protocol and
Baud Rate” in the “Operation” section.
MTPX Plus Series • Matrix Software 111