Filter
Top Products
Hardware status — Provides an overall view of the status of the matrix switcher,
including the power supply voltages, the temperature status, the Remote RS-232/RS-422
port configuration, and the installed and updated firmware status (see figure 68).
Fan is operating properly.
Fan has failed.
The MTPX Plus fans will
never display the “Not
Installed” status.
Figure 68. Status window
Name Presets — Allows you to name each of the 16 memory presets.
NOTE: Preset names are limited to 12 upper- and lower-case alphanumeric
characters, space, and the _ and / characters. The HTML language
reserves certain characters for specific functions (see “Special Characters“
in the “Programming Guide” section).
Show RS-232 Strings — Displays the ASCII commands that are used by the current
configuration. You can refer to these for SIS programming.
I/O Group settings — Displays the inputs/outputs groups window, which allows you to
assign inputs and outputs to any one of four groups (or no group).
Initialize — Initializes and clears any or all of the following: ties, presets, audio
configuration, preset names, icon names, and icons.
Audio Input Configuration selection
Displays the Configure Audio Options window (see figure 64 on page 114), which shows
the audio gain level settings for each input and allows you to change them. The level is
expressed as the magnitude (number of decibels) and polarity (positive, gain or negative,
attenuation) of the audio adjustment.
MTPX Plus Series • Matrix Software 117