Filter
Top Products
IN1606 and IN1608 Series Scaling Presentation Switcher • Internal Web Pages 96
Audio Configuration Page
From the Audio Configuration page, audio inputs and outputs are configured and mixed.
Click the Audio Config icon (see figure 58,
6
on page 86) on the Global Navigation
Bar
to open this page. There are four tabs for adjusting program and microphone inputs,
mixing inputs, and configuring outputs.
Configuring the audio in order of the tabs from left to right helps ensure proper setup of
input and output levels as well as mix and listening levels.
Configuration overview
Figure 69. Audio Configuration Tabs
1. From the Line Input tab (see figure 69,
1
), set audio input formats and set the input
gain at optimal settings.
a. Set the audio format of each input (see Audio format on page 97).
b. Set the input gain for analog inputs (see Input gain on page 98).
2. From the Mic/Line Input tab (
2
), set the mic gain at optimal settings.
a. If necessary, apply phantom power to the applicable microphone inputs (see
Phantom power on page 100).
b. Set the microphone input gain (see Mic/line gain on page 101).
c. If desired, apply a high pass filter to the microphone inputs (see High pass filter on
page 100).
d. If desired, enable ducking for the microphone inputs (see Ducking parameters on
page 102).
3. After the line input gain and mic gain are properly set, mix the audio levels and set tone
levels from the Mix Controls tab (
3
). If the results from this step are satisfactory, skip
steps 4 and 5 as no other settings need to be adjusted.
a. Set the mic mix levels (see Mic mix levels on page 103).
b. Set the listening volume of the microphone inputs (see Mic volume on page 104).
c. Set the listening volume of the program audio (see Program volume on page 104).
d. Set the bass and treble levels for the program material (see Bass and treble on
page 106).
4. If necessary, set output limiters, mix options, or volume from the Output tab (
4
).
a. If desired, apply an output limiter to the desired outputs (see Limiters on
page 107).
b. Set mix options of the output (see Mix options on page 108).
c. Set the output volume (see Output gain on page 109).