Filter
Top Products
IN1606 and IN1608 Series Scaling Presentation Switcher • Installation 16
Output Connections
100-240V ~ -- A MAX
1
2
CONFIGURABLE
HDMI
HDMI
5
6
7
8
C
RS-232 IR
RS-232 IR
TxRx TxRxG
TxRx Tx RxG
TxRx Tx RxG
HDMI
A
B
3
4
INPUTS
OUTPUTS
TxRx
RS-232
G
LAN
2x25W(8Ω)/2x50W(4Ω)
RESET
AUDIO INPUTS
OUTPUTS
REMOTE
LL1R R
L2
R
L
3
R
CLASS 2 WIRING
L4
R
L5R
+48V
+48V
12
LR
VARIABLE
IN1608 SA
2
MIC/LINE
L6
R
SIG LINK
DTP IN
SIG LINK
DTP IN
SIG LINK
DTP OUT
50/60 Hz
RS-232 IR
OVER DTP
OVER DTP
OVER DTP
AMPLIFIED OUTPUT
D
AB C
A
TP output and corresponding RS-232/IR
Over TP connector — output C
B
HDMI output connectors — outputs A and B
C
Analog audio output connectors
D
Amplified audio output
connector
Figure 11. Output Connectors (IN1608 SA)
A
TP output connector (IN1608 Series only) — Depending on the IN1608 model,
connect either a DTP receiver (IN1608 DTP models only) or HDBaseT-compatible
device (IN1608 HDBT models only) to the RJ-45 connector (see Twisted Pair
Recommendations for DTP and HDBaseT Communication on page 22).
NOTE: Depending on the connected receiver, the DTP output signal can travel up to
330 feet (100 meters) or 230 feet (70 meters) without a loss of signal integrity.
• The -0x models of the IN1608, IN1608 SA, and IN1608 MA are capable of
DTP 230 transmission.
• All other IN1608 DTP models are capable of DTP 330 transmission.
Signal Support
DTP output HDBaseT output
• HDCP-compliant digital video
• Re-embedded program audio into the
TMDS output or analog audio
• DTP standard RS-232 and IR
pass-through signals on the associated
5-pole captive screw connector
• Remote power to a DTP receiver
• HDCP-compliant digital video
• Re-embedded program audio into the
TMDS output
• RS-232 and IR pass-through signals
on the associated 5-pole captive
screw connector
ATTENTION:
• Do not connect this connector to a computer or telecommunications network.
• Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
• DTP remote power is intended for indoor use only. No part of the network that
uses DTP remote power should be routed outdoors.
• L’alimentation DTP à distance est destiné à une utilisation en intérieur
seulement. Aucune partie du réseau qui utilise l’alimentation DTP à distance ne
peut être routée en extérieur.
Signal LED — Lights when the scaler is sending a signal.
Link LED — Lights when a valid link is established.